Mechanical Replacement Parts List - Omnivision PVQ-130W Service Manual

Control Unit. However, the battery cover is available separately as a replacement
part.
4. Main Cam Push Nut (Ref. No. 414) is not reusable.
If removed, install a new one.
12.1.3. Electrical Replacement Notes
1. Unless otherwise specified;
All resistors are inΩ Ω Ω Ω , 1/4 W,±5%, carbon, K = 1,000Ω Ω Ω Ω ,
M = 1,000 kΩ Ω Ω Ω .
All capacitors are inµ µ µ µ F, P =µ µ µ µ µ µ µ µ F,±10%.
All coils are inµ µ µ µ H, M = 1,000µ µ µ µ H,±10%.
2. Abbreviation
RTL: Retention Time Limited
This indicates that the retention time is limited for this item. After the
discontinuation of this item in production, it will no longer be available.
NR: Non Repairable Board Ass'y
MGF CHIP: Metal Glaze Film Chip
C CHIP: Ceramic Chip
COMPLX CMP: Complex Component
W FLMPRF: Wirewound Flameproof
C.B.A.: Circuit Board Assembly
P.C.B.: Printed Circuit Board
E.S.D.: Electrostatically Sensitive Devices
3. SERVICE OF CHIP PARTS
When servicing chip parts, please use a soldering iron of less than 30 W. Refer to
"IC, TRANSISTOR AND CHIP PART INFORMATION" page.
4. When replacing 0Ω Ω Ω Ω resistor, a wire can be substituted for it.
5. When installing the IC2501 (AN3846SC or AN3845SC) or Capstan Stator C.B.A., be
sure to apply Silicon Grease (VFK1301). Refer to "Capstan Stator C.B.A." of
MECHANISM SECTION in DISASSEMBLY/ASSEMBLY PROCEDURES.
6. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No. E21) has already
been pre-adjusted at the factory, do not try to adjust the UHF/VHF TUNER/TV
DEMODULATOR UNIT. The UHF/VHF TUNER/TV DEMODULATOR UNIT
replacement part is available as a complete assembly unit only.
7. EEPROM IC (IC6004),
TV/VCR MAIN C.B.A. replacement note:
When replacing EEPROM IC (IC6004) or TV/VCR MAIN C.B.A., be sure to write the
initial data with remote control.

12.2. MECHANICAL REPLACEMENT PARTS LIST

123