Omnivision PVQ-130W Service Manual page 29

A. Soldering Iron
Use a pencil-type soldering iron that uses less than 30 watts.
B. Solder
Eutectic Solder (Tin 63%, Lead 37%) is recommended.
C. Soldering time
Do not apply heat for more than 4 seconds.
D. Preheating
Leadless capacitor must be preheated before installation. -(266°F ~ 302°F)
(130°C ~150°C) for about two minutes.
Note:
A. Leadless components must not be reused after removal.
B. Excessive mechanical stress and rubbing of the component electrode must be
avoided.
2. Removing the leadless component
Grasp the leadless component body with tweezers and alternately apply heat to
both electrodes. When the solder on both electrodes is melted, remove the
leadless component with a twisting motion.
Note:
A. Do not attempt to lift the component off the board until the component is
completely disconnected from the board by a twisting action.
B. Be careful not to break the copper foil on the printed circuit board.
3. Installing the leadless component
A. Presolder the contact points on the circuit board.
Fig. 9-1
Fig. 9-2
29