Omnivision PVQ-130W Service Manual page 41

When installing Degaussing Coil, place the Degaussing Coil correct position.
3. Installation of VCR Chassis Unit
When installing 2 Screws (S-5), slide the Holder Unit of the Cassette Up Ass'y
(Refer to "METHOD FOR LOADING/UNLOADING OF
NOTES) to tighten screws. Then, slide it back to theEJECT Position.
Make sure that Mechanism and Cassette Up Ass'y are in theEJECT Position. (Refer
to "EJECT Position
4. Removal of TV/VCR Main C. B. A.
Work carefully so as not to break Sensor LED when lifting the Mechanism Chassis
and Cassette Up Ass'y.
Installation of Mechanism Chassis and Cassette Up Ass'y onto TV/VCR Main C.B.A.
A. Make sure the Mode Select SW. on the TV/VCR Main C.B.A. is inEJECT position.
If not, rotate the Mode Select SW. until the alignment projection is in theEJECT
Position.
B. Make sure the Mechanism and Cassette Up Ass'y are in theEJECT Position.
(Refer to "EJECT Position
PROCEDURES.)
Fig. D7
Confirmation" in DISASSEMBLY/ASSEMBLY PROCEDURES.)
Confirmation" in DISASSEMBLY/ASSEMBLY
MECHANISM" in SERVICE
Fig. D8
41