Mitsubishi Wi-Fi Control Installation Manual page 9

(Improper handling may have consequences, including injury or damage to house.)
• To prevent damage from static electricity,
touch a nearby metal body to discharge
static electricity from yourself before
touching the Wi-Fi Adaptor.
• Static electricity from the human body may
damage the Wi-Fi Adaptor unit.
• Do not install the Wi-Fi Adaptor in a place
with high steam levels, such as bathrooms.
• Avoid places where water is splashed
or where condensation forms on walls.
Installing in such places can cause electric
shock or breakdown.
• Do not install the Wi-Fi Adaptor in places
with direct sunlight or where the ambient
temperature is 40ºC or more or is 0ºC
or less. Direct sunlight and high or low
temperature environments may cause the
Wi-Fi Adaptor to deform or breakdown.
• Please ensure that the access point
supports both WPS connection and the
WPA2-AES encryption setting before
commencement of the installation of the
MAC-559IF-E.
• To complete connection of the
MAC-559IF-E to the Wi-Fi service physical
access to the access point may be required.
• Details of the heat pump and
MAC-559IF-E can be recorded on page 2
'Setting Information'.
Mitsubishi Electric's Wi-Fi Adaptor is designed for communication to Mitsubishi Electric's
Wi-Fi service.
Third party Wi-Fi Adaptors cannot connect to Mitsubishi Electric's Wi-Fi service.
Mitsubishi Electric is not responsible for any (i) under performance of a system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product; which is caused by
or arises from connection to and/or use of any third party Wi-Fi Adaptor or any third party Wi-Fi
service with Mitsubishi Electric equipment.
For the latest information regarding Wi-Fi Control:
New Zealand based enquiries please visit: www.mitsubishi-electric.co.nz/wifi
Australian based enquiries please visit: www.mitsubishielectric.com.au/wifi
Caution
• Do not use in special environments.
• Do not use in places with high oil use
(including machine oil), high steam levels,
or sulfuric gas - this may lead to severe
decrease in functionality and damage to
parts.
• Turn off power supply of connected
equipment when performing construction or
wiring work.
• Failure to turn off the power supply to
the connected equipment may lead to
malfunction or breakdown of the Wi-Fi
Adaptor or connected equipment.
• Dismantling the indoor unit
Please refer to the indoor units "service
manual" for detailed instructions for
accessing the control adaptor connector
CN105 on the indoor unit control PCB.
Note
• The end user should read and accept the
terms and conditions of the Wi-Fi service
before commencement of the installation of
MAC-559IF-E.
• The MAC-559IF-E should not be installed
and connected to any Mitsubishi Electric
system which is to provide cooling or
heating to critical applications.
9