Table of Contents
Advertisement
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
®
Legend
II
Turn off pool pump. Then take the Wall Fitting and
twist lock the Wall Fitting clockwise into the Wall
Adapter. To disconnect the Legend
twist counter clockwise. The Wall Adapter should
remain in the pool wall.
B. Turning On/Off the Legend
®
The Legend
II operates off a filtration pump coming
from the equipment pad, and can be turned on or off
by merely turning on/off your pump time clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum tube
®
and open the Velcro
debris bag and dump debris.
If you have a lot of debris in your pool, especially
after a storm, you can run your Legend
shorter cycles per day and empty the debris bag
between cycles.
Reconnect the debris bag to the vacuum tube.
Do NOT over turn.
®
If the Velcro
Brand fastener on top of the debris bag
does not stay secure, rinse well, let it dry and clean
with a stiff brush.
A Helpful Hint: It is easier to empty the debris bag
when it is dry. A second bag may be used while the
full debris bag is drying.
It's best to empty the debris bag when it becomes
®
half full. The Legend
if the bag is not overloaded.
7
®
II, unlock and
®
II
Brand fastener at the top of
®
II will have better performance
D. Periodic Maintenance
The following parts are wear items that should be
checked, maintained or replaced as needed. Wear
items are considered any working or moving part(s)
being worn due to the use of the cleaner. Wear items
are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a
secondary filter. This screen is to keep debris that is
passed by the pool filter out of the Legend
Running the Cleaner without the filter screen can
damage the Legend
II in two
A continuous plugged or dirty screen is a sign of
problems in your pool filtration system and you need
to contact your local pool professional.
To clean the filter screen, pull the screen out from
inside the Wall Fitting and rinse thoroughly and push
back inside the wall fitting.
Whenever cleaning, back washing or repairing filter,
remove the wall fitting and flush out the dedicated
line before using the Legend
®
II and will void the warranty.
®
II.
LEGEND® II INSTALLATION MANUAL
®
II.
Advertisement
Table of Contents
