Table of Contents
Advertisement
1. Tips on Hose Cutting for Larger Pools.
If the hose is short of the farthest end of the pool,
add an additional section of hose (Part # LX17), one
Swivel (Part # LX19), two Mender Nuts w/O-Rings
(Part # LX20), and one Hose Float (Part # LXD10).
See diagram below. Re-measure and follow guide
on page 3-4.
LEGEND® II INSTALLATION MANUAL
TIPS FOR CUTTING HOSE IN A SMALL POOL,
AND FOR ADDING HOSES FOR LARGE POOLS
1. Tips on Hose Cutting for Smaller Pools.
If the hose hangs over the deck more than 9 ft. or the
pool is less than 6 ft. deep and narrow, cut 36 in. off
the 5 ft. section hose at the end of the feed hose and
remove one float. Then remove one 6 ft. hose (see
diagram), 1 swivel and 2 mender nuts. Re-measure
and cut hose according to the guide on page 3-4.
12
Advertisement
Table of Contents
