Related Manuals for Pentair PROWLER P Series
Summary of Contents for Pentair PROWLER P Series
- Page 1 PROWLER P-SERIES ROBOTIC INGROUND POOL CLEANER INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS / SAVE THESE INSTRUCTIONS G-INSB-PROW-P BK0019424...
-
Page 2: Declaration Of Conformity
Unless indicated otherwise, names and brands of others that may be used in this document are not used to indicate an affi liation or endorsement between the owners of these names and brands and Pentair. Those names and brands may be the trademarks or the registered trademarks of these parties, or others. -
Page 3: Table Of Contents
CUSTOMER SERVICE / TECHNICAL SUPPORT If you have questions about ordering Pentair Aquatic Systems, (“Pentair”) replacement parts, and pool products, please use the following contact information: Customer Service Technical Support +39 050716166 / +39 050716169 e-mail: techsupport.poolemea@pentair.com orders.pooleu@pentair.com poolemea@pentair.com www.pentairpooleurope.com... -
Page 4: Important Warning And Safety Instructions
30mA. result in damage to the pool fi nish or the vinyl liner, Pentair HAZARDOUS SUCTION. Do not disclaims any liability for repairs or replacement to any of these play with cleaner or apply to structures or components of the customer’... - Page 5 - Roll up the cable so that it has no kinks cleaners. Pentair is not responsible for any pattern removal, - Store the Pool Cleaner in a protected area out of direct sun / abrasions or markings on vinyl liners.
-
Page 6: Introduction
INTRODUCTION System overview The robotic cleaner sweeps the pool fl oor and walls collecting dirt and debris in its fi lters. This user manual explains how to operate the robotic cleaner, including cleaning, maintenance and storage procedures. Note: This manual reviews several different models with variations in components. Robotic cleaner operation Once the robotic cleaner is placed in the pool and activated, it operates according to its program. -
Page 7: Operation
OPERATION Placement of the Power Supply Place the power supply at least 3.5 meters from the pool and at least 12 cm above ground. CAUTION: The power supply is not water resistant; it must not be exposed to water or to direct sunlight. Press the plastic snap on the zip ties in order to release the fl oating cable. -
Page 8: Starting The Robotic Cleaner
OPERATION Starting the robotic cleaner Connect the power supply to the wall socket. The on/off button will lit and the robotic cleaner will start its cleaning program. If the power supply is already connected to the wall socket, the on/off button will fl ash to indicate that the robotic cleaner is in standby mode. -
Page 9: Maintenance And Storage
MAINTENANCE AND STORAGE Cleaning the fi lter(s) The two fi lter(s) must be cleaned after each cleaning cycle. Press the button to release the fi lter and pull it out of the cleaner. Open the fi lter case. Spray water on the outer sides of the fi lter and then spray water towards the inner side of the fi lter to clean all the dirt and debris. -
Page 10: Using The App
USING THE APP Starting the Robotic Cleaner using the App Download and install the Application from Google Play or App Store. Use the QR code at the bottom of the next page. 2. Open the App. 3. Open Bluetooth option on your phone. 4. -
Page 11: Download The App
USING THE APP Settings: Change the settings of the Pool Cleaner: Delay Start (in hours): The Pool Cleaner will start the cleaning cycle after the chosen period of time. Alerts: Shows different alerts received from the Robotic Operation Time: pool Cleaner The Pool Cleaner or the Power will clean the pool... -
Page 12: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Corrective Action CLEANER DOES NOT There is no electricity in the wall (1) Disconnect cleaner from the power and TURN ON socket: control unit. (2) Disconnect power supply from the wall socket, wait 30 seconds and reconnect.
Need help?
Do you have a question about the PROWLER P Series and is the answer not in the manual?
Questions and answers