Figure 2 Turbidity sensor components
1 Turbidity sensor
2 Mounting brackets (4x)
3 Mounting screws (4x)
Figure 3 Controller components
1 Controller
2 Sealing gasket for panel mount,
Neoprene
3 Mounting foot (2x) for panel mount
4 Mounting bracket
5 Ground screw, green
Installation
W A R N I N G
Multiple hazards. Only qualified personnel must conduct the tasks
described in this section of the document.
Installation guidelines
Install the turbidity sensor as near as possible to where the controller is
to be installed. Contact the manufacturer if a distance longer than 9 m
(30 ft) is necessary.
6 Flat washers, ¼–in. ID (8x)
7 Hex nuts, M6 (8x)
8 Pan head screws, M6 x 1.0 x
20 mm (4x)
9 Pan head screws, M6 x 1.0 x
100 mm for pipe mount (4x)
10 Pan head screws, M6 x 1.0 x
150 mm for panel mount (4x)
English 7