Panasonic U-8MF2E8 Service Manual page 107

2. Detailed Settings Function
Setting the Flap Separately (When setting the CZ-RTC2)
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps operate
in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
<Procedure>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
button and select the address (unit No.) of the
indoor unit to set. At this time, the fan at the indoor
unit begins operating.
3 " ," unit No. "
group control), item code "
" " are displayed blinking on the remote
controller LCD display.
4 Designate the item code "
Temperature Setting
Electrical component box
Flap 1
Flap 2
=91
Flap 3
Flap
and buttons
,
" (or " " in the case of
," and settings data
" by adjusting the
/ buttons.
=90
Flap 4
=93
=92
5
Press the timer time
the desired setting data.
Flap position
5
* Setting data "
Setting data Flap position during operation
Without separate setting
Swing
Move to position 1 and stay
Move to position 2 and stay
Move to position 3 and stay
Move to position 4 and stay
Move to position 5 and stay
When the flap position is set to 4 or 5 and the unit
is in the cooling or dry mode, the flap position is moved
to 3 and the operation is started. (refer to Fig.3)
NOTE
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position 1 . (refer to Fig.3)
6 Press the button.
(The display stops blinking and remains lit, and setting
is completed.)
If you wish to change the selected indoor unit, follow
the step 2 .
7 Press the
button to return to normal remote
controller display.
7
6
1
4 - 5
3WAY SYSTEM
Remote Controller Functions
/ buttons to select
1
2
3
4
Fig. 3
" (refer to Fig.3)
3
2
4
5
4