Table of Contents
Advertisement
O
PERATION
Reset Scaling
To reset the scaling settings to default:
1.
Access the
Scale
2.
Turn the <SCROLL/ENTER> knob until Scale is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob until Reset is selected.
5.
Press the <SCROLL/ENTER> knob.
Zoom/Crop Image
The Zoom/Crop Image menu provides the zoom functions for cropping the video output.
To access the Zoom/Crop Image menu:
1.
Access the
Scale
2.
Turn the <SCROLL/ENTER> knob until Advanced is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob until Zoom/Crop Image is selected.
5.
Press the <SCROLL/ENTER> knob.
There are 7 different zoom values that can be set to precision. Each one stretches the video output in 1, 2,
or 4 directions.
1.
Access the
Zoom/Crop Image
2.
Turn the <SCROLL/ENTER> knob to select from Top (1), Bottom (1), Top/Bottom (2), Left (1),
Right (1), Left/Right (2), or Center (4).
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease the
zoom, from 0–_ _ _ _ (The maximum values are determined by the scale and the other zoom
values. Editing these values may cause changes to the other zoom values).
5.
Press the <SCROLL/ENTER> knob.
6.
Repeat steps 2-5 until the zoom is set as desired.
Reset Zoom
To reset the zoom values to 0:
1.
Access the
Zoom/Crop Image
2.
Turn the <SCROLL/ENTER> knob to select Reset.
3.
Press the <SCROLL/ENTER> knob.
Map
The Map settings define the arrangement and number of panels for each port, and well as semi-global and
individual offsets.
To access the Map menu, press <MAP> (if it is set to default) or:
1.
Press <MENU> to access the menu.
2.
Turn the <SCROLL/ENTER> knob until Map is selected.
3.
Press the <SCROLL/ENTER> knob.
Offset Settings
The Offset Settings determine the semi-global positions of ports 1 and 2 together and ports 2 and 3
together on the connected panel assembly.
1.
Access the
Map
2.
Turn the <SCROLL/ENTER> knob to select Offset Settings.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from Port 1/2 Offset
X (ports 1 and 2 horizontal position), Port 1/2 Offset Y (ports 1 and 2 vertical position), Port 3/4
Offset X (ports 3 and 4 horizontal position), or Port 3/4 Offset Y (ports 3 and 4 vertical position).
5.
Press the <SCROLL/ENTER> knob.
6.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease the
value, from 0–65535.
7.
Press the <SCROLL/ENTER> knob.
8.
Repeat steps 4-7 until the offsets are set as desired.
VIP Drive 43s User Manual Rev. 1
menu.
menu.
menu.
menu.
menu.
29
Advertisement
Table of Contents
