Table of Contents
Advertisement
O
PERATION
Test Pattern
The Test Pattern function sends one of 20 patterns to the connected panel assembly to test the panels, the
connections, and the mapping.
To access the Test Pattern menu:
1.
Press <MENU> to access the menu.
2.
Turn the <SCROLL/ENTER> knob until Test Pattern is selected.
3.
Press the <SCROLL/ENTER> knob.
To enable or disable the Test Pattern function:
1.
Access the
Test Pattern
2.
Turn the <SCROLL/ENTER> knob until Test Pattern is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select Off or On.
5.
Press the <SCROLL/ENTER> knob.
Test Pattern Mode
To select which pattern is sent to the connected panel assembly:
1.
Access the
Test Pattern
2.
Turn the <SCROLL/ENTER> knob until Mode is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from 1–20.
5.
Press the <SCROLL/ENTER> knob.
Some panel configurations may be too small to view Test Patterns 3–10 and 13
properly.
Test Pattern Mode 19
With Test Pattern Mode 19 selected, after pressing the <SCROLL/ENTER> knob, 3 new options will
appear. Test Pattern Mode 19 will only output to the connected panels after one of these options is
selected.
After selecting Test Pattern Mode 19:
1.
Turn the <SCROLL/ENTER> knob until Red, Green, or Blue is selected.
2.
Press the <SCROLL/ENTER> knob.
3.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease the
color value, from 0–255.
4.
Press the <SCROLL/ENTER> knob.
Test Pattern Mode 20
With Test Pattern Mode 20 selected, after pressing the <SCROLL/ENTER> knob, 3 new options will
appear.
•
Horizontal Gradient Steps
1.
Turn the <SCROLL/ENTER> knob until HOR STEP is selected.
2.
Press the <SCROLL/ENTER> knob.
3.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease
the number of horizontal steps in the gradient, from 2, 4, 8, 16, 32, or 64.
4.
Press the <SCROLL/ENTER> knob.
•
Vertical Gradient Steps
1.
Turn the <SCROLL/ENTER> knob until VER STEP is selected.
2.
Press the <SCROLL/ENTER> knob.
3.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to increase or decrease
the number of vertical steps in the gradient, from 0, 4, 8, 12, 16, 20, 24, 28, 32, 36, 40, 44,
48, 52, 56, 60, or 64.
4.
Press the <SCROLL/ENTER> knob.
•
Color
1.
Turn the <SCROLL/ENTER> knob until VER STEP is selected.
2.
Press the <SCROLL/ENTER> knob.
3.
Turn the <SCROLL/ENTER> knob to select the color of the gradient, from Red, Green,
Blue, or White.
4.
Press the <SCROLL/ENTER> knob.
VIP Drive 43s User Manual Rev. 1
menu.
menu.
23
Advertisement
Table of Contents
