For Built-In Usb Interface - Epson TM-T88V Technical Reference Manual

For Built-in USB Interface

When using the serial or parallel interface, it is not necessary to change the DIP switch setting
but their function changes. For the details, see
Interface" on page 58.
DIP Switch Bank 1
SW Function
1-1 Auto line feed
1-2 Receive buffer capacity
1-3 ∼
Undefined
1-6
1-7 Undefined
Setting of USB power-saving
1-8
function
* Varies depending on the interfaces.
DIP Switch Bank 2
SW Function
2-1 Handshaking (BUSY condition)
R e s e r v e d ( D o n o t c h a n g e
2-2
setting)
2-3 ∼
Selects print density
2-4
Sets the release condition of the
receive buffer BUSY state. (This
2-5
function is effective when DIP
Switch 1-2 is set to off.)
2-6 ∼
R e s e r v e d ( D o n o t c h a n g e
settings)
2-7
2-8 Reserved
* Varies depending on the interfaces.
For DIP Switch 2-1 (BUSY condition), see also
"For Serial Interface" on page 56
ON
Always enabled Always disabled
45 bytes
—
—
Disabled
ON
• Offline
Receive buffer full
• Receive buffer full
Fixed to OFF
See "Selecting the Print Density (DIP Switches
2-3/2-4)" on page 62.
R e le as e s t he BU SY R e l e a s e s t h e B US Y
s t a t e w h e n t h e s t a t e
remaining capacity remaining capacity
of the receive buffer of the receive buffer
reaches 138 bytes. reaches 256 bytes.
Fixed to OFF
—
"Selecting the BUSY Status" on page
Chapter 4 Advanced Usage
and "For Parallel
Default
OFF
setting
OFF
4 KB OFF
OFF
*
Enabled OFF
Default
OFF
setting
OFF
OFF
OFF
w h e n t h e
OFF
OFF
*
62.
59
4