Table of Contents
Advertisement
8-13.CHECKING THE VIDEO SEARCH REWIND
BACK TENSION
• Remove the cassette housing control assembly.
• After short-circuiting between TP5102 and TP5103
provided goes left at VTR display PWB, plug in the
power cord.
• Checking
1. After pressing the play button, press the rewind button,
and set the video search rewind mode.
2. Place the torque gauge on the take-up reel disk, and turn
it counterclockwise very slowly (one rotation every 2 to
3 seconds) and check that the torque is within the set
value 3.4 ± 1.5mN⋅m (35 ± 15gf⋅cm).
Torque gauge
CCW
Figure 8-12.
Notes:
Set the torque gauge securely on the take-up reel disk.
If it is not secure, the measurement will be incorrect.
8-14.C H E C K I N G T H E P I N C H R O L L E R
PRESSURE
• Remove the cassette housing control assembly.
• After short-circuiting between TP5102 and TP5103
provided goes left at VTR display PWB, plug in the
power cord.
• Checking
Press the play button to set the playback mode.
Capstan shaft
1. Detach the pinch roller from the capstan shaft.
Do not separate excessively. Or the pinch lever and
pinch double action lever may disengage.
2. Engage the tension gauge adapter with the pinch roller
shaft, and pull in the arrow direction.
3. Gradually return the pinch roller, and measure the
pulling force when the pinch roller contacts the capstan
shaft.
Take-up reel disk
4. Make sure that the measured value is within setting 9.0
N to 11.8 N (900 to 1,200gf).
8-15.CHECKING AND ADJUSTMENT OF
• Remove the cassette housing control assembly.
• After short-circuiting between TP5102 and TP5103
provided goes left at VTR display PWB, plug in the
power cord.
• Turn off the power switch.
• Setting
1. Open the cassette tape (T-120), and fix with tape.
2. Set the cassette tape in loading state.
3. Put the weight (500g) on the cassette tape.
4. Turn on the power switch.
5. Make the adjustment with the beginning of a T-120 tape.
25
Pinch roller
Tension gauge adapter
Figure 8-13.
TENSION POLE POSITION
500g
Weight to prevent
float (500g)
Figure 8-14.
DV-NC55U/C/M
Tension gauge
900 - 1,200gf
(T-120)
Advertisement
Table of Contents
