Adjusting The Tilt Of The Backrest; Adjusting The Suspension - QUERIDOO Sportrex2 User Manual

Utilisation

Adjusting the tilt of the backrest

For the backrest you can set two tilt angles by moving its upper horizontal bar:
128 degrees: The horizontal bar is secured in the rear position.
ƒ
This tilt is pre-set at the factory and is recommended for carrying small children who may fall
asleep during the journey.
115 degrees: The horizontal bar is secured in the front position.
ƒ
This more upright seating position is recommended for older children who participate actively
in the journey.
Tip!
Do not adjust the tilt during the journey as this can take some time.
f Release the backrest's upper horizontal bar by
removing the star grip screws on both sides.
Put the horizontal bar into its new position between
f
the cabin frame holes.
f Insert the star grip screws through the holes into the
horizontal bar and tighten the screws securely.
Tension the harnesses on the rear of the cabin, see
f
"Tightening the backrest" on page

Adjusting the suspension

The suspension of the
Sportrex2
time. They are pre-set at the factory to maximum spring deflection in order to provide maximum
comfort.
If necessary, you can adjust the suspension's
individually:
f Turn the disk above the spring clockwise to make the
suspension harder.
Turn the disk anticlockwise to make the suspension
f
more comfortable.
Danger!
When altering the hardness, it is essential to ensure that you make the same
adjustments on both struts. Different spring deflections can have a negative influence
on riding performance. Alter the factory setting only in exceptional cases.
28 – 02|2016 – Subject to change.
16.
adjusts itself automatically to the load being carried at the
hardness
Sportrex2 – Q6000A