Setting The Mode; Adjusting The Buggy Wheel - QUERIDOO Sportrex2 User Manual

Utilisation

Setting the mode

You can use the
Sportrex2
Trailer mode: Carrying children in the
ƒ
Buggy mode: Using the
ƒ
Walker mode: Carrying children in the
ƒ
The table below shows the main settings that you must make for particular components for the
respective mode:
Component
Buggy wheel
Tow bar
Pennant
Push handle
Hand strap on the push
handle
5-point safety harness
Bicycle
Optional accessories
(see "Accessories" on
page 12)
Danger!
Before every journey, make sure that necessary adjustments have been made for the
particular mode. For details of this, see the instructions in the following sections.

Adjusting the buggy wheel

You must make the following settings, depending on the mode.
Removing the buggy wheel (Trailer mode)
The buggy wheel must not be fitted in Trailer mode, because in certain riding situations it can
make contact and cause serious accidents.
f Undo the quick-release clamp with which the wheel suspension is secured on the cabin frame.
f Lift the cabin slightly at the front and completely remove the buggy wheel.
Tip!
Carry the buggy
flexibly at your destination.
Sportrex2
the chapter
Sportrex2 – Q6000A
in one of the following modes:
Sportrex2
like a buggy
Sportrex2
Sportrex2
Status of the components in mode
Trailer
must be completely
removed
unfolded
(pay attention to tow
bar load!)
must be mounted
maximum height
(107 cm)
–
must be fastened
the correct coupler
must be installed
Rear light
(mandatory in poor
visibility or darkness)
wheel e.g. in the storage space in order to
"Installing the buggy wheel" on page 17.
when cycling
when jogging or walking
Buggy
fitted
(freely rotating)
folded in
recommended
comfortable height
wrapped around a
wrist
must be fastened
–
–
allow you to use the
Instructions for re-mounting it can be found in
Subject to change. – 02|2016 – 21
Walker
fitted
(fixed)
folded in
recommended
comfortable height
wrapped around a
wrist
must be fastened
–
Jogger air wheel with
hand brake