Mounting The Push Handle - QUERIDOO Sportrex2 User Manual

Assembly
Insert a screw through the tube into a hole in the wheel guard.
f
Loosely screw the self-locking nut onto the thread. When doing this, make sure that the
f
circular side of the nut is not against the thread.
f Connect the second screw in the same way.
f Use a size 4 Allen key to alternately tighten both screw connections (tightening torque
max. 4 Nm).
Mount the second wheel guard in the same way for the other wheel.
f

Mounting the push handle

The push handle is secured to the top of the cabin frame with two robust tube clamps. It has
multiple height settings and is used for pushing, pulling and manoeuvring your
becomes necessary, it performs an important safety function as a roll-bar.
Prepare the push handle by fully unfolding it. To do this, keep the light grey pushbuttons
f
pressed on both sides, see
f Position yourself behind the upright cabin.
f Loosen the two star grip screws at the bottom end of
the push handle to enable the tube clamps to be easily
pushed onto the tubes of the cabin frame.
f With both tube clamps, hold the push handle on
the tubes of the upper cabin frame. Two recesses in
the cover (next to the ventilation window) show the
intended mounting position.
Attach the tube clamps in turn onto the cabin frame
f
tubes by applying gentle pressure. Secure them by
partly tightening the star grip screws.
f Align the push handle horizontally by pushing the tube
clamps all the way up at the same height.
Securely tighten the star grip screws in order to fix the
f
tube clamps to the cabin frame.
Danger!
Make sure that the push handle is also mounted for every journey in Trailer mode.
Only then does the cabin have a roll-bar.
Sportrex2 – Q6000A
"Adjusting the push handle" on page
. And if it
Sportrex2
20.
Subject to change. – 02|2016 – 15