Inserting The Wheels; Fitting The Wheel Guard - QUERIDOO Sportrex2 User Manual

Assembly

Inserting the wheels

Place the cabin on one side to allow the wheel to be inserted more easily.
f
Insert one wheel into the cabin's axle retainer:
f
– Hold the wheel so that you can press your thumb
onto the rubber cap on the outside of the wheel
hub.
– Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
– Insert the wheel's push-in axle as far as it will go
into the axle retainer.
– Release the rubber cap to secure the push-in axle.
Pull on the wheel to check that the wheel is locked in
f
the axle retainer.
f Turn the cabin onto its other side and insert the
second wheel in the same way.
Danger!
After mounting the wheels, secure the
prevent it from rolling away, see
Check whether there is sufficient air in the wheels (recommended air pressure: 1.7 – 2.4 bar).
f
If necessary, use an air pump for car valves to top up with air.

Fitting the wheel guard

The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars
or similar obstacles.
Tilt back the cabin and place it on its reverse side. This makes the lower cabin frame accessible
f
for assembly.
f Prepare the wheel guard by removing the two prefitted screws from the holes.
Hold the wheel guard close to the wheel against
f
the cabin frame so that the following conditions are
fulfilled:
– The holes on the wheel guard face the holes in the
cabin frame tube.
– The curved outside of the wheel guard widens
towards the wheel.
14 – 02|2016 – Subject to change.
whenever you park it so as to
Sportrex2
"Applying the parking brake" on page
Sportrex2 – Q6000A
20.