Table of Contents
Advertisement
Assembly
–
Align the rear wheel so that it can turn freely.
–
Align the coupler so that it faces horizontally to the rear.
Tighten the connection firmly in order to secure the rear wheel:
f
–
Quick-release axle: Tighten the cap nut until you can close the clamp with a certain amount
of pressure.
–
Full axle: Tighten the nut with a spanner.
Tip!
The coupler can be permanently mounted on the bicycle. Additionally available
couplers enable you to use the
page
12.
The supplied universal coupler is suitable for mounting on most rear-wheel versions. If
it does not fit your bicycle, you can find suitable special couplers and conversion sets
on the Weber Technik GmbH website:
Sportrex2 – Q6000A
on different bicycles, see
Sportrex2
www.weber-products.de
"Accessories" on
Subject to change. – 02|2016 – 19
Advertisement
Table of Contents
