Dodge 2001 Ram 1500 Owner's Manual page 145

3 - 72 FRONT AXLE - 248FBI
DIFFERENTIAL CASE BEARINGS (Continued)
Fig. 47 Install Differential Side Bearings
1 - HANDLE C-4171
2 - DIFFERENTIAL CASE
3 - BEARING
4 - TOOL C-4190
PINION GEAR/RING GEAR
REMOVAL
NOTE: The ring and pinion gears are service in a
matched set. Do not replace the ring gear without
replacing the pinion gear.
(1) Raise and support the vehicle.
(2) Remove differential from housing.
(3) Place differential case in a vise with soft metal
jaw.
(4) Remove ring gear bolts from differential case.
(5) Drive ring gear from differential case with a
soft hammer (Fig. 48).
(6) Mark the pinion yoke and propeller shaft for
installation alignment.
(7) Remove propeller shaft from pinion yoke and
tie propeller shaft to underbody.
(8) Hold pinion yoke with Holder 6719A and
remove pinion yoke nut and washer.
(9) Remove pinion yoke with Puller C-452 and
Flange Wrench C-3281 (Fig. 49).
(10) Remove pinion gear from housing (Fig. 50).
(11) Remove pinion seal with a pry bar or screw
mounted slide hammer.
Fig. 48 Ring Gear
1 - CASE
2 - RING GEAR
3 - HAMMER
Fig. 49 Pinion Yoke
1 - YOKE HOLDER
2 - YOKE
3 - YOKE PULLER
(12) Remove oil slinger and front pinion bearing.
(13) Remove front pinion bearing cup with Driver
D-158 and Handle C-4171 (Fig. 51).
(14) Remove rear bearing cup with remover D-162
and Handle C-4171 (Fig. 52).
(15) Remove collapsible preload spacer (Fig. 53).
(16) Remove rear pinion bearing from pinion with
Puller C-293-PA and Adapters C-293-37 (Fig. 54).
(17) Remove pinion depth shims from the pinion
shaft and record thickness.
BR/BE