Training Interruption; Resumption Of Training; Urement); Recall Last Training - Kettler FB600 Training And Operating Instructions

Training and Operating Instructions
18
GB
Training interruption/end of training
With less than 10 pedal rotations per minute, the electro-
nics assembly of the training device identifies a training
interruption. The animation wheel is displayed empty. The
achieved training data are displayed. Rotations, speed
and pulse level are displayed as average values with the
symbol Ø.
• Pressing "DISP" will stop and start change of display.
The training data are displayed for 4 minutes. If you do
not press any button nor train during this period of time,
time electronics assembly of the training device switches
to standy-by mode and displays the time.
Comment:
Training interruption is identified with a delay of a few
seconds.

Resumption of training

If you resume training within 4 minutes, the last values
continue to be counted up or down.
RECOVERY – Function
Recovery pulse measurement
Press "RECOVERY" at the end of training.
The electronics assembly of the training device measures
your pulse 60 seconds in reverse.
The difference between start pulse and end pulse helps to
determine a fitness grade (see example F 1.6). The dis-
play will be stopped after 20 seconds.
"RECOVERY" interrupts the recovery pulse function or the
fitness mark display.
If no pulse is measured in the beginning or at the end of
the reverse counting, the error message "Err" is displayed.
Recall last training (MEM) with
total kilometres (ODO)
When pressing RESET or switching off the display (stand-
by), the last training values are saved automatically.
Recall of last training data
• Minus – (press shortly when time is displayed)
All segments are shortly displayed
The last training time is displayed
• Press DISP
The display skips to the next range.
Stopping last display of training data
• Press Minus