Tally DT-230 User Manual page 67

Tally Dascom DT-210/230
The commands listed below in the first column are defined as "obsolete commands" in the ESC/POS
command system.
This printer supports both upward-compatible commands and obsolete commands. However, the
upward-compatible commands are recommended to use.
Obsolete command
ESC i Partial cut (one point left uncut)
ESC m Partial cut (three points left uncut)
ESC u Transmit peripheral device status
ESC v Transmit paper sensor status
FS p Print NV bit image
FS q Define NV bit image
GS v 0 Print raster bit image
NOTE: "Obsolete commands" are commands that are supported by legacy models; however it is
recommended to replace them with upward-compatible commands, because they will not be supported in
the future products.
Upward-compatible command
GS V
GS V
GS r
GS r
GS ( L <Function 69>
GS ( L <Function 67>
GS ( L <Function 112 + 50>
53