Table of Contents
Advertisement
Network
TCP/IP Setup
HTTP/RTSP port
-The default HTTP port is 80, it is also be used as RTSP port.
RTP port range -
It is for UPnP port forwarding, 1 camera actually use 2 RTP ports, one
for video, the other for audio. (See UPnP setup)
HTTP/RTSP Authentication method -
Authentication.
Select Basic Authentication or Digest Access
The camera is set up to obtain the IP address
automatically (DHCP) by default. Should you may wish
to assign the IP address manually, use the
page to enter the address details.
Obtain an IP address automatically (DHCP):
1)
If your network supports a DHCP server (e.g.
router) select this option to have the IP address is
assigned automatically.
2)
If you select
Obtain an IP address automatically
and
you should select
Obtain a DNS Server address
automatically.
Use the following IP address:
Select this option when a
fixed IP is required.
IP address -
Type the IP address of your camera.
Subnet mask -
Type the subnet mask.
Default gateway -
Type the default gateway.
Obtain DNS Server address automatically:
If your network supports a DHCP server (e.g. router)
select this option to have the DNS Server address is
assigned automatically.
Use the following DNS server address:
Primary DNS IP address -
Type the IP address of the
primary DNS server.
Secondary DNS IP address -
the secondary DNS server, if necessary.
TCP/IP Setup
Type the IP address of
35
Advertisement
Table of Contents
