Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET20MK Use & Care Manual

Install properly.. .
I. Allow M inch (I25 cm] space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall.
I-rjB!AFep~~b ,.l?i I k,ImwdlBY:*-w,L+
,*p 1Cr'. i . . *,;':~,~sq9i'
Level refrigerator-freezer.. .
Right to Raise;
Left to lower
I. Remove base grille [see page 8).
2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
lnslde
labels before using the refrigerator
To remove any remalnlng glue:
1, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, garollne, car-
bon tetrachlorlde, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
. . ;.ixarkw
Clean it...
Clean your refrigerator
before using it.
See cleaning instructions
on page 9.
Plug it in...
j-prong grounding
type wall receptacle,
Retrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extenslon cord. Use a recep-
tacle which cannot be turned otl with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.