Table of Contents
Advertisement
5. Operation
28
on was selected:
Put the humidity probe into the reference medium and
2
wait for the equalisation period to elapse.
- The current humidity reading and the calibration
point (nominal value) are displayed.
Start the calibration menu with
3
Select the desired option with
4
with
· no: Humidity value is not calibrated.
· YES: Humidity value is calibrated.
no was selected:
Continue with step
YES was selected:
- The calibration is carried out.
Repeat steps
5
- When calibration has been completed, the
instrument changes to the next setting function.
3
To r r egister t t he r r adio p p robe:
Radio probes may only be used in countries in which
they have been Type Approved (see application infor-
mation of the radio probe).
The setting function for radio probes is only available if
a radio module (accessory part) is inserted into the
measuring instrument.
See the chapter
If no radio module is inserted:
Continue with the objective
Each radio probe has a probe ID (RF ID). This consists of
the last 3 digits of the serial no. and the position of the
slide switch in the radio probe (H or L).
Configuration mode is opened,
is lit.
The radio probe is switched on and the transfer rate is
set to 2 readings per second (see the advice on using
the radio probe).
:
.
5
to
for the 2
2
4
C
OMMISSIONING
.
/
and confirm
calibration point.
nd
.
T
A
O
O SET
UTO
FF
is flashing and AUTO
.
Hide quick links:
Advertisement
Table of Contents
