Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.
Control Panel Disassembly (cont.)
4.
Slide control panel out.
5.
Remove screws securing touch board.
Screw
Touch Board
6.
Remove touch board.
7.
Remove screws securing clock.
Screw
© 2010 Viking Preferred Service
Clock
WARNING
8.
Repair or replace clock as necessary.
9.
Reverse procedure to reinstall.
Note: When replacing touch board, make sure that
center connection "seats" before installing screws.
Note: DDOE305T model shown.
Connector
51