Initialization, Power On-Selftest & Error Messages; Board Initialization Sequence - pro bel V6402 HD User Manual

6.2 Initialization, Power On-Selftest & Error Messages
6.2.1

Board Initialization Sequence

Every time a board goes through a power-on cycle, either by re-seating the board in the rack or by
triggering the manual reset, a sequence of initialisation and self-test events is being carried out by the on-
board microcontroller.
If anything goes wrong, an error message is shown on the front panel display and program execution halts.
The following table shows the error messages and their meaning:
ERROR 01
ERROR 02
ERROR 03
ERROR 04
ERROR 05
ERROR 06
ERROR 07
ERROR 08
ERROR 09
ERROR 10
ERROR 11
ERROR 12
ERROR 13
ERROR 14
ERROR 15
ERROR 16
ERROR 17
ERROR 18
68
V6402, V6404, V6406,V6408
Flash erasing failed
Flash programming failed
Main program checksum error after programming
Bootloader checksum error after programming
No program loaded and no valid upgrade in Flash Stick
Bootloader upgrade required but no valid bootloader upgrade in Flash
Stick
STATUS stayed low after CONFIG pulsed low
DONE stayed high after CONFIG pulsed low
STATUS went low during configuration
DONE stayed low after configuration
Error writing to local EEPROM
Error reading from EEPROM
Initialising EEPROM to default data
Initialising parameters to default data
Receive buffer overflow
Receive overrun
Receive framing error
Receive parity error
and V6418 HD converters
Issue 6