Fuse; Flash Memory Card - pro bel V6402 HD User Manual

2.6.3

Fuse

There is only one fuse on these modules, which is in series with the main DC input.
FS1 Fuse 2 Amp Wire
ended
2.6.4

Flash Memory Card

The Flash Memory Card stores the firmware for the Microcontroller and the FPGA and is essential for the
operation of the module. If this card is missing, the front panel display will come up with an error message
(ERROR 10). The Flash Memory Card sits in a socket with a location peg to the right. In case of a
firmware upgrade, one has to make sure that the replaced card sits firmly and straight in the socket with
the location peg mating with the positioning hole on the baseboard.
The Flash Memory Card is re-programmable. Customers are kindly asked not to throw it away after
having upgraded a module with a newer firmware version. A Vistek service technician will collect it on
his/her next visit or it can be put in an envelope and sent back to the postal address shown on the cover of
this manual.
22
In series with the +15V input to the module on the I/O
daughter board.
Flash Memory Card
(Side view)
Socket (Top view)
V6402, V6404, V6406,V6408
and V6418 HD converters
Location peg
Positioning hole
Issue 6