Table of Contents
Advertisement
Instructions for use Hartenberger High-Tech-UW-Lamp nano compact
J
SPARE-O-RING
The spare O-ring (48 x 1,6 50° hardness) is locate d in the rear cover adjacent
to the plastic cover.
K
PLUG-IN CONNECTION
The plug in connection serves as an electrical and mechanical connection
between the power pack and the electronic control panel.
L
REAR HOUSING COVER
The rear housing cover can be removed for accessing/removing/replacing the
cells pack and/or the halogen bulb.
M
CHARGING CONTACTS
The charging contacts are for charging the cell pack while the housing is
closed. The contacts are colour coded: +/red (right contact) and -/blue (left
contact).
N
MAGENTIC SWITCH / TRANSPORT LOCK
The magnetic switch is used for all the control functions of the lamp and the
electronics. To lock the lamp and prevent inadvertent operation, the magnetic
switch, press the switch „in". This is the so-called transport setting.
O
LED DISPLAY
The 4 LEDs show the brightness set and the remaining capacity of the cell
pack.
P
OVERPRESSURE INDICATOR
If the pin protrudes from the housing, and over pressure exists in the housing.
Q
HOLE FOR A LANYARD
The hole in the handle provides an attachment point for a lanyard for better
security during use and may prevent loss of the lamp.
R
HANDLE
The handle provides a good hold on the lamp, even when wearing thick
neoprene gloves or mittens. If required for video mounting, the handle can be
drilled and an M8 thread cut for mounting to video rigs.
©Hartenberger Unterwassertechnische Geräte GmbH Rights reserved for technical changes. Issue 01.2011
5
Advertisement
Table of Contents
