Using The Underwater Lamp - Hartenberger Nano compact Instructions For Use Manual

Underwater hand lamp

Hide thumbs

Table Of Contents

Table of Contents

Instructions for use Hartenberger High-Tech-UW-Lamp nano compact

BEFORE EACH USE

Before each use, the threads, sealing surfaces and O-ring must be checked for

integrity and cleanliness. (See Closing the housing, page 8). If the bulb has been

removed for transport, it should be refitted into the socket. Refit the halogen bulb

in the socket which may have been removed for transportation. Only release the

transport lock to the unlocked position immediately before use. (See page 12).

USING THE UNDERWATER LAMP

Warning !

When the lamp is turned on, direct the beam away from yourself and others.

Do not point the beam directly at others. If there is a defect on the lamp, the

front glass plate may be forced out of the front of the housing with

explosive force.

Warning !

Water inside the housing (especially sea water) can have drastic results

consequences after some a period if time. Therefore, during the use of the

lamp please check repeatedly, whether water has found its way inside. Do

this by holding the lamp on the slant pointing down, thus the ray of light

pointing away from the body. Then look at the front glass from the side.

If there is water inside the housing, bring the dive to an end by following the

diving rules and open the housing as soon as possible (see page 22).

TRANSPORT LOCK

Release the transport lock immediately before use.

To unlock the switch, push it from the transport lock position (lock) outwards

(unlock) the switch must physically click into the unlocked position.

MAGENTIC SWITCH / SWITCH UNIT

The electronic controls are activated by pushing the switch to the right (+) or to

the left (-). The signals are transmitted via magnetically sensitive hall sensors.

This feature avoids any mechanical connection through the lamp's housing

reducing the risk of water ingress and general wear.

ACTIVATING THE ELECTRONICS / CELL PACK CAPACITY DISPLAY

If the switch is pushed to the left (-) for approx. 3 seconds, the electronics are

activated from the energy saving „sleep" mode. The LED display illuminates and

shows the charge status of the cell pack for approx 3 seconds.

One LED = 25%, two LED´s = 50%, three LED´s = 75%, four LED´s = 100%

To view the capacity display after the 3 seconds, Slide the switch one short push

to the left (-) again.

If the lamp is not used for a period of 10 hours, the electronics will automatically

return to the energy saving "sleep" mode.

BRIGHTNESS / DIMMER

The electronics allow the lamp to be used in 4 levels of brightness (50%, 75%,

100% and using over voltage; 125%).

Using the lamp at dimmed (lower) settings will save energy and extend the burn

time of the lamp with one charge.

If the switch is pushed for a short time (approx ½ second) to the right (+), the

lamp will turn on to the first brightness stage (50%).

Each subsequent push to the right (+) will increase the brightness 25%.

Each subsequent push to the left (-) will decrease the brightness 25%.

Table of Contents