Table of Contents
Advertisement
20
Instructions for use Hartenberger High-Tech-UW-Lamp nano compact
CHARGER OFF-SHORE II
Use only manufacturer approved cells, do not connect any non-approved
!
cells.
The charger off-shore 1/6 is suitable for charging the High-Tech-mini lamp nano
compact.
The max. charging current is approx. 1.8 Amps.
The charging time for the nano compact is approx. 2 hours.
The charger uses the latest technology with a wide range input voltage rating and
accepts any voltage between 100 and 250V and frequencies between 45 and 65
Hz. It is not necessary to mechanically pre-select the local voltage. All
Hartenberger cell packs with 5-12 cells (6 – 14.4V) are identified by the charger
when connected and will have an optimal efficient charge.
When charging the nano compact lamp, the cell pack monitoring is carried
out by the electronic module in the cell pack.
First connect the charger to the mains by plugging in the mains cable. All the
functions of the charger are displayed via 2 LEDs. The charger is monitored by a
special electronic module inside the charger. This modules requires 1-1.5
seconds to carry out a self test after which time the LEDs will illuminate.
Charger LEDs when charging NC or NMH re-chargeable cells:
LED I :
Green
Red
Off
Next connect the charging cable to the charger using the chinch plug. The
charging cable is plugged into the charging sockets on the lamp with banana
plugs. When connecting the cable(s) to the lamp and/or charger, guide the plugs
straight into the sockets and do not use excessive force. Ensure the correct plug
is connected in to the charging socket, follow the colour coding and labelling
(red/+ on the right, blue/- on the left )
Avoid short circuiting the plug pins (e.g. with a metal object crossed over
the two pins). Ensure the charger is dry and away from moisture and the
cooling slots are not covered or restricted particularly in extreme
climates/conditions.
LED II :
Red
Green blinks Fast charge to 100 % of the cell pack capacity.
Off
Charger LED when charging lithium manganese re-chargeable cells:
When the cell pack is fully charged (all 4 LEDs on the nano compact display
of off) the electronic module in the lamp will cut off the charging current to
the lamp. LED II on the charger will be red (cell pack not connected) or may
blink irregularly
©Hartenberger Unterwassertechnische Geräte GmbH Rights reserved for technical changes. Issue 01.2011
Mains supply connected, charger is functioning correctly.
Mains supply connected, charger is overloaded or defective.
No mains supply connected.
No cell pack connected (pause).
Trickle charge, cell pack is 100% charged.
Advertisement
Table of Contents
