Transport - Hartenberger Nano compact Instructions For Use Manual

Underwater hand lamp

Table of Contents

Instructions for use Hartenberger High-Tech-UW-Lamp nano compact

Warning!

Terminate the dive following standard safe diving practices and open the

housing as soon as possible.

An extended period of flooding, in particular salt water flooding, may cause

a failure of this warning function.

OVER PRESSURE WARNING

If the pressure inside the housing increases (e.g. as a result of gas production

due to electrolysis after flooding and/or if the cell(s) are defective), an over

pressure indicator in the form of a small plug located to the left of the LED display

will protrude approx 6mm (¼") from the housing. The LED display will begin to

blink quickly (4 x per second) and as a safety precaution the power of the lamp

will automatically reduce to 25%. Turn off the lamp as soon as possible.

Warning!

Terminate the dive following standard safe diving practices and open up the

housing as soon as possible, (see page 22).

AFTER USE

Warning!

After the dive is completed, examine the lamp for signs of flooding or water

ingress as soon as possible. To carry out this check, hold the lamp upside

down with the glass plate pointing down and look at the glass plate from

the side for any signs of moisture/water ingress.

After each use, the lamp should be thoroughly rinsed in clean, fresh water. During

this rinsing, operate the switch in all directions to rinse under the switch.

When the lamp is operating, the temperature in the housing will increase and a

slight overpressure will form inside the housing. If the housing is opened

immediately after use, this slight overpressure will cause excessive friction on the

threads of the covers and/or the O-ring seals, the cover will be difficult to open.

For this reason we recommend that the lamp is left unopened (unless flooding

has occurred) for several minutes after it is switched off.

TRANSPORT

After use, the switch should be locked in the off position to prevent

inadvertent operation/use. To lock the switch in the off position, push the

switch towards the LED display, it should click into the transport lock

position. When correctly locked, the switch cannot be pushed to the left or

right.

Warning !

If the lamp is to be transported or stored without direct supervision, the

halogen bulb must be removed from the socket and stowed (see page 9).

This is a precaution in case a defective electronic module turns the lamp

on. This heat generated by the halogen bulb my cause damage to items

adjacent to the lamp/glass/bulb.

Table of Contents