• 1 NPort 5200 2-port Serial Device Server • Documentation & Software CD • NPort 5200 Series Quick Installation Guide Optional Accessories • DK-35A: DIN-Rail Mounting Kit (35 mm) • CBL-RJ45M9-150: RJ45 (8-pin) to DB9 (M) cable, 150 cm •...
Page 3
Reset Button—Press the Reset button continuously for 5 sec to load factory defaults: Use a pointed object, such as a straightened paper clip or toothpick, to press the reset button. This will cause the Ready LED to blink on and off. The factory defaults will be loaded once the Ready LED stops blinking (after about 5 seconds).
To view detailed information about NPort 5200 Administration Suite, click on the Documents button, and then select “NPort 5200 Series User’s Guide” to open the pdf version of this user’s guide. The PComm Lite program is also included in the Documentation &...
Page 5
NOTE The NPort 5232/5232I/5232-T/5232I-T have 2 RS-422/485 ports. The pin assignments are the same as the NPort 5230/5230-T’s port 2. Refer to the “NPort 5200 Series User’s Manual” for more details. Pin Assignments and Cable Wiring— NPort 5210/5210-T RJ45 (8-pin) Connector Pinouts...
RJ45 (8-pin) to DB9 Female (Cable Name: CBL-RJ45F9-150) RJ45 (8-pin) to DB9 Male (Cable Name: CBL-RJ45M9-150) Specifications Power Requirements NPort 5210/5210-T: 12 to 48 VDC, 325 mA at 12V (max.) NPort 5230/5230-T: 12 to 48 VDC, 325 mA at 12V (max.) NPort 5232/5232-T: 12 to 48 VDC, 280 mA at 12V (max.) NPort 5232I/5232I-T: 12 to 48 VDC, 365 mA at 12V (max.) Operating Temp.
Regulatory Approvals EN55022 Class A, FCC part 15 Subpart B Class A EN 61000-4-2 ESD: contact 4 kV; air 8 kV EN 61000-4-3 RS: 3 V/m (80MHz to 1 GHz) EN 61000-4-4 EFT: Power 1 kV; Signal 0.5 kV EN 61000-4-5 Surge: AC 1 kV EN 61000-4-6 CS: 3 V EN 61000-4-8 EN 61000-4-11...