Switch Off; Set Time & Date; Program Start - Webasto Air Top 2000 ST Operating Instructions Manual

Visit www.butlertechnik.com for more technical information and downloads.
Switch on

Switch off

Set time/date
View time

Program start

time
View/Delete
selected times
Program
operating time
Set remaining
time
Remote control
Vehicles
with ADR
equipment
Manual: Press the
Automatic: By programming the start time
Manual: Press the
Automatic: By programming the operating period
When heater unit is running: By setting the remaining time
Press the button for more than two seconds - the time flashes -
set the time using the
day.
Ignition off: Press
Press the button - program number flashes - set the start time us-
ing the and
the button several times, you can set the program numbers 2 and
3 or go to the time mode.
Press the button several times until the required program number
is displayed. To delete the selected time press the
time is displayed with no program numbers.
The heater must be switched off. Press the
onds - the operating duration flashes - set the required operating du-
ration using the
Set the required remaining time (1 to 120 minutes) using the
buttons. The remaining time is the time that the heater will con-
tinue to operate. It can only be changed whilst the heater is operating
and the ignition is off.
Possible using an external optional immediate heat button.
It is not possible to set a time on ADR vehicles. The remaining time
will be shown on the display whilst the heater is operating. The time
can be adjusted.
www.butlertechnik.com
button (continuous heating mode)
button again
and buttons - the day flashes - set the
button
buttons - the day flashes - set the day. If you press
and buttons (10 to 120 minutes).
button until the
button for three sec-
and