Convection Bake Element Removal; Broil Element Removal; Control Components Accessed; Control Panel Assembly Removal - Viking RDSCE2305B Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Convection Bake Element Removal

1. Remove convection fan cover (see Convection
Fan Cover Removal).
2. Remove screws that attach the convection bake
element to the oven liner.
3. Mark and disconnect wires from convection
element.
4. Reverse procedure for installation.

Broil Element Removal

1. Remove oven door (see Door Assembly
Removal).
2. Remove screws and bracket from broil
assembly.
3. Remove screws that hold the broil assembly to
the back of the oven liner.
4. Remove screws that hold the broil assembly to
the top of the oven liner.
Note: Use care when pulling broil assembly into the
oven cavity. Make sure the connectors remain
on the broil assembly.
5. Carefully pull connectors through the oven cavity
wall and lower the broil assembly.
6. Mark and disconnect connectors from broil
element.
Note: During installation, make sure broil connectors go
back through the oven liner.
7. Reverse procedure for installation.
38
! WARNING

Control Components Accessed

1. Remove oven door (see Door Assembly
Removal).
2. Remove two screws below control panel, see
photo below.
3. Lift up to remove control panel assembly from
keyhole screws.
4. Place control panel assembly on protective
surface on the top of range.
5. Reverse procedure for installation.

Control Panel Assembly Removal

1. Access control components (see Control
Components Accessed).
2. Mark and disconnect all connectors to remove
control panel from range.
3. Reverse procedure for installation.
©2012 Viking Preferred Service