Bake Or Broil Burner Orifice Removal; Convection Fan Assembly Removal; Control Components Accessed; Control Panel Assembly Removal - Viking RDSCG230-5B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Bake or Broil Burner Orifice Removal

1. Remove bake or broil burner (see Bake or Broil
Burner Removal).
2. Remove orifice from manifold.
(Bake burner orifice shown)
3. Reverse procedure for installation.

Convection Fan Assembly Removal

1. Remove oven door (see Door Assembly Removal).
2. Remove screws and fan cover from oven cavity.
3. Remove four outer screws and convection motor
assembly from oven cavity.
4. Mark and disconnect two connectors from convection
motor assembly.
5. Remove left hand nut and fan blade from convection
fan.
6. Reverse procedure for installation.
©2012 Viking Preferred Service

Control Components Accessed

1. Remove oven door (see Door Assembly Removal).
2. Remove all surface burner knobs.
3. Remove screws and bezels from control panel
assembly where knobs have been removed.
4. Remove screws from below control panel assembly.
5. Lift up to remove control panel assembly from
keyhole screws.
6. Place control panel assembly on protective surface
on the top of range.
7. Reverse procedure for installation.

Control Panel Assembly Removal

1. Access control components (see Control
Components Accessed).
2. Mark and disconnect all connectors to remove control
panel from range.
3. Reverse procedure for installation.
Disassembly
23