Maintenance Instructions - Maytag MDG28PDCWW Installation Instructions Manual

Reverse The Strike
1. Use a small flat-blade screwdriver to remove plug strip
from the dryer door opening. Slide the head of the
screwdriver under the plugs, being certain not to scratch
the dryer surface. Lift the plastic strip from the dryer slowly
to prevent distortion of the plug strip.
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.
A. Plug strip
B. Door strike

Maintenance instructions:

Clean lint screen after each cycle.
n
Removing accumulated lint:
n
From inside the dryer cabinet:
•
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
From the exhaust vent:
•
Lint should be removed every 2 years, or more often,
depending on dryer usage.
Keep area around dryer clear and free from combustible
n
materials, gasoline, and other flammable vapors and liquids.
Keep dryer area clear and free from items that would obstruct
n
the flow of combustion and ventilation air.
B.
A.
MAINTENANCE INSTRUCTIONS
Reinstall The Door
1. Reattach door to dryer front panel with the 4 screws.
Partially install the screw with keyhole opening first, and fit
the keyhole opening in the hinge over the screw. Then install
the remaining 3 screws and tighten all 4 screws.
A.
Install this
screw first
B.
A. Dryer front panel
B. Door assembly
2. Check for fingerprints on the glass. Clean glass if necessary.
3. Close door and check that it latches securely.
If dryer does not operate, check the following:
Electrical supply is connected.
n
Circuit breaker is not tripped or house fuse is not blown.
n
Door is closed. Listen closely to hear the door switch activate.
n
Control is set up properly and display shows cycle time.
n
Cycle selection button has been pushed firmly.
n
For gas dryers, check that gas supply shutoff valves are set
n
in open position.
If you need assistance:
Contact your authorized Maytag
distributor. To locate your authorized Maytag
Laundry distributor, or for web inquiries, visit
www.MaytagCommercialLaundry.com.
If you cannot locate your distributor, the Commercial Laundry
Support Center will answer any questions about operating or
maintaining your dryer not covered in the Installation Instructions.
Just dial 1-800 NO BELTS (1-800-662-3587)—the call is free.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located in the dryer door opening.
Commercial Laundry
®
Commercial
®
23