Clean Fuel Filter; Engine Oil Replacement - Jet JIN3500E Operation Manual

ClEAN FUEl FIlTER

ENGINE OIl REPlACEMENT

1. Unscrew the screw (1) and take off the
left exterior cover (2).
2. Drain the fuel in the fuel tank. Hold the
tube clip (3) toward downward and pull
out the fuel tube (4) which is connected
to the fuel tank, then disassemble fuel
filter.
3. Put the fuel filter (5) into noncombustible
or higher flash point solvent and clean it.
4. Assemble fuel filter to the main jet (6) on
the fuel tank then install tube clip.
Avoid draining the engine oil immediately
after stopping the engine. The oil is hot
and should be handled with care to avoid
burns.
1. Place the generator on a level surface
and warm up the engine for several
minutes.
2. Unscrew the screw (1) and take off the
sight glass of engine oil (2).
3. Lift and tilt the machine; take off the end
cap (3) at the bottom plate of machine
4. Remove the oil filler cap.
5. Place an oil pan under the engine,
remove the oil drain bolt (6) drain the oil
from the oil tank.
6. Check oil filler cap (4), O-ring (5), Oil
drain bolt (6), Oil filler cap packing (7).
Replace immediately with new compo-
nents if any are damaged.
7. Assemble oil drain bolt and oil filler cap
packing.
8. Add oil to a suitable level, tighten oil filler
cap.
9. Assembly the end cap at the bottom of
machine .
10. Assembly the sight glass of engine oil.
maintenance
27