Battery Charging - Jet JIN3500E Operation Manual

• If the generator is connected to multiple loads or electricity consumers,
please remember to first connect the one with the highest starting
current. And last connect the one with the lowest starting current.
• If the generator is overloaded, or if there is a short circuit in a connected
appliance, the overload indicator (red) will go ON. The overload
indicator (red) will stay ON, and after about 4 seconds, the connected
appliance(s) will shut off, and the output indicator (green) will go OFF.
Stop both engines and investigate the problem. Determine if the cause
is a short circuit in a connected appliance or an overload, correct the
problem and restart the generator.

bATTERy CHARGING

TIP:
• The generator DC rated voltage is 12V.
• Start the engine first, and then connect the generator to the battery
for charging.
• Before starting to charge the battery, make sure that the DC
protector is turned on.
1. Start the engine.
2. Connect the red battery charger lead to the positive (+) battery
terminal.
3. Connect the black battery charger lead to the negative (-) battery
terminal.
4. Turn the ESC "OFF" to start battery charging.
• Be sure the ESC is turned off while charging the battery.
• Be sure to connect the red battery charger lead to the positive (+)
battery terminal, and connect the black lead to the negative (-) bat-
tery terminal. Do not reverse these positions.
• Connect the battery charger leads to the battery terminals se-
curely so that they are not disconnected due to engine vibration or
other disturbances.
• Charge the battery in the correct procedure by following instruc-
tions in the owner's manual for the battery.
• The DC protector turns off automatically if current goes above the
rated flow during battery charging. To restart charging the battery,
turn he DC protector on by pressing its button to "ON". If the DC
protector turns off again, stop charging the battery immediately
and consult a servicing dealer.
NOTICE
operation
19