Makita UH200D Instruction Manual page 14

Fig.28
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
1. Basic alignment line on the tool housing
2. Pins
010897
Adjust the three detent pin position so that these pins
are lined up at right angle in relation to the basic
alignment line on the tool housing.
Fig.29
Fit the crank with its recessed part facing upwards onto
the detent pins. At this time, apply a small amount of
grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
Fig.30
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
Fig.31
Turn the shear blades upside down and install it so that
the detent pins on the tool fit in the hole in the shear
blades. Make sure that the shear blades are set in place
securely as far as they reach the base plate.
Fig.32
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
Fig.33
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
Fig.34
At this time, make sure that the lockimg lever fits in the
groove in the undercover.
Remove the blade cover and then turn on the tool to
check it for proper movement.
2
on the
on the locking
on
14
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
Fig.35
Remove the base frame and place the tool upside down.
CAUTION:
Before placing the tool upside down, be sure to
•
remove the base frame (only for Model UM164D).
Fig.36
To remove the shear blade, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
Fig.37
Take out the undercover, shear blade and crank in order
from the tool.
1. Storage case
011043
NOTE:
In the 2-way usage, the removed hedge shear
•
blade need to be sheared in the blade storage
case and then stored for future use.
Installing or removing base frame
CAUTION:
Before installing or removing base frame, be sure
•
to install the blade cover.
When installing or removing base frame, take care
•
that your fingers are not be pinched between the
tool and base frame.
Fig.38
To remove the base frame, upset the tool and take it out
of the groove grabbing its bottom.
Fig.39
To install the base frame, fit the protrusion of base frame
near the change lever into the hole for the sheared grass
height setting. With the base frame so fitted, pull the
lower part of base frame and fit the other part of the base
frame in the groove in the tool.
Adjusting the shearing height
Fig.40
Changing the position of holding the change lever allows
three-stepped setting for sheared grass height (10 mm,
on the undercover
on the locking lever.
1