Makita UH200D Instruction Manual page 13

If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Hedge shear blade cover
•
Hedge shear blade assembly
•
Chip receiver for hedge trimming
•
Makita genuine battery and charger
•
For cordless grass shear use
This tool can be used as a grass shear by using the grass
shear blade (optional accessory) and 2-way change set.
To use this tool as a grass shear, replacing the hedge
shear blades with the grass shear blades is required.
1
1. Grass shear blade
2. Grass shear blade cover
3. Storage case
4. Base frame
011042
Long handle attachment (for Grass Shear)
•
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing blade cover
CAUTION:
Be careful not to contact the shear blade when
•
installing or removing the blade cover. Contacting
the shear blade may cause personal injuries.
Fig.26
Fig.27
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
towards the tool from the front.
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing grass shear blades
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing shear blades. Failure to switch off and
remove the battery cartridge from the tool may
For removing the hedge trimmer blades, refer to the
aforementioned section titled "Removing the hedge
shear blades".
For installing the grass shear blade, refer to the section
below titled "Installing or removing grass shear blades".
•
•
•
•
•
2
•
NOTE:
•
•
1. Crank
2. Undercover
3. Shear blades
010895
To install the grass shear blade, prepare the crank,
undercover and new grass shear blade
13
Grass shear blade assembly (for Grass Shear)
2-way change set consisting of the following three
accessories
Grass shear blade cover (for Grass Shear)
Storage case (for blade bottom section)
Base frame (for Grass Shear)
3
result in serious injury from accidental start-up.
When replacing the shear blade, always wear
gloves without removing blade cover so that hands
and face does not directly contact the blade.
Failure to do so may cause personal injury.
Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
blades refer to the reverse of a package for
accessory shear blades.
1 2
4
3