Terminal Block With Clamp - Viking DGVU2004B–30 Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. After servicing, reconnect electrical power and gas supply. Before placing appliance into
operation, always check for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.

Terminal Block with Clamp

To access Block with Clamp:
1. Remove main top (see Main Top Access section,
page 16).
2. Remove securing screws. Slide cover forward to
remove.
3. Remove wiring connectors from terminal block.
Power Cord
Terminal Block
© 2011 Viking Preferred Service
WARNING
Screw
Screw
Clamp
Connectors
4. Remove terminal block securing screws from
the outside of cooktop.
Power Cord
5. Rotate terminal block to gain access and loosen
clamp screw.
Terminal Block
Clamp
6. Remove and repair/replace terminal block as
necessary.
Note: Loosen power cord screws if removing power
cord from terminal block.
7. Reverse procedure to reinstall.
Screw
Power Cord
Screw
25