Burner Assembly - Viking DGVU2004B–30 Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. After servicing, reconnect electrical power and gas supply. Before placing appliance into
operation, always check for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.

Burner Assembly

To access Burner Assembly:
1. Remove main top (see Main Top Access section,
page 16).
2. Remove wiring connector from spark plug.
Burner Assembly
3. Disconnect burner inlet pipe.
© 2011 Viking Preferred Service
WARNING
Connector
Burner Inlet
4. Remove securing screws and burner assembly.
5. Repair/replace burner assembly as necessary.
6. Reverse procedure to reinstall.
Note: Make sure correct burner assembly size is
reinstalled (see Parts Location Exterior, pages 13-14
for correct burner sizes).
Note: DVGU260-5B shown.
Screw
Burner Assembly
Screw
18