Initialization; Default Settings - Epson LX-810 User Manual

A Initialization
^ There are two ways that the printer can be initialized (returned to
^ the default settings) through the hardware and one through the
software. These are described in the following table:
Hardware initialization . The power is turned on.
• The printer receives an iNTf signal at the paral
lel Interface (pin 31 goes LOW).
Software initialization
. The software sends the ESC @ (initialize the
printer) command.
A
Default settings
The table below shows the default conditions that become valid
when the printer is initialized.
•m.
Item
Reset to:
A
Top of form position
Current paper position
Left and rlgtit margins
Cancelled
Line spacing 1/6-inch line spacing
A,
Vertical tab position
Cleared
-
Horizontal tab positions
Every eight characters
VFU cfiannel
Channel 0
Font selection
The current SelecType setting
Condensed mode
The current SelecType setting
Character spacing The current DIP switch setting
-
Justification
Left justification
-
Special printing effects
Cancelled
Graphic mode assignment
ESC K = ESC * 0, ESC L = ESC * 1,
ESC Y = ESC * 2, ESC Z = ESC * 3
A
Technical Specification 8-15
A