ESC EM
Commands A.rranged by Topic
Turn Cut Sheet Feeder Mode On/Off
Format:
ASCII code:
ESC
EM
n
Decimal:
27
25
n
Hexadecimal:
IB
19
n
Comments:
The following values can be used for n:
4: Mode is truned ON.
0: Mode is turned OFF:
The variables are the characters "0" (48 decimal) and "4"
(52 decimal).
The command should not be used unless the cut sheet feeder is
installed. It is ignored if any value other than 0 or 4 is used for
n.
The ON/OFF status of cut sheet feeder mode can also be
selected by DIP switch 2-2.
BEL
Beeper
Format:
ASCII code:
BEL
Decimal:
7
Hexadecimal:
07
Comments:
Sounds the printer's beeper.
Command Summary
9-11