Epson LX-810 User Manual page 221

Paper Handling
Problem Solution
Even with the paper
release lever set
correctli/ to the
single sheet position,
the single sheet and
continuous paper
feed together and
jam.
When the
LOAD/EJECT button
is pressed to load
continuous paper,
the platen does not
rotate and paper is
not loaded.
The paper release
lever is correctly
switched to the
continuous paper
position, hut when
the LOAD/EJECT
button is pressed,
the platen rotates
backward and the
paper comes off the
sprockets.
When the paper
release lever position
is changed, the
printer beeps
continuously.
The continuous paper may not have fed
backward far enough to reach the standby
position before you changed the position
of the paper release lever. Remove the
jammed paper and try again. Also, check
that the PAPER OUT light comes on before
changing the position of the paper release
lever to make sure that the continuous
paper is completely ejected. Refer to 2-15.
The paper release lever may not be in the
proper position. Pull the lever forward to
the continuous paper position.
Refer to 2-20.
A single sheet may be in the paper guide,
causing the continuous paper to come off
the sprockets. When using continuous
paper, always make sure to remove any
single sheets remaining in the paper guide,
and make sure that the paper guide is in
the lowered position. Refer to 2-20.
You may have changed the paper release
lever position with paper in the paper
path. Remove the paper from the paper
path or return the paper release lever to
the previous position. Refer to 2-17, 2-20.
T roubleshooting 7-21