Summer Ventilation; Plant Maintenance; Routine Maintenance To Be Performed By The User; Annual Air Heater Inspection - Accorroni MEC25-85 Technical Information

Gas-fired
Table of Contents

Advertisement

b) after the fan(s) have turned off, disconnect the
electric power supply at the mains switch
c) close the gas on-off valve
11.5 SUMMER VENTILATION (appliance
equipped with a remote-control panel)
During the summer, the MEC air heater can be
used to ventilate the environment, excluding the
burner according to the following operations:
a) close the gas on-off valve
b) turn on the electric power supply using the
mains switch
c) set the switch (A) to the "VENTILATION"
position
d) to stop the fan, set the switch (A) to the "OFF"
position.

12. PLANT MAINTENANCE

12.1 ROUTINE MAINTENANCE TO BE
PERFORMED BY THE USER
It is recommended to carry out the following
operations at the beginning of each heating season
and then at least once every month during
operation:
WARNING! The operations described in points
a) b) and c) below must be performed while
the air heater is not functioning, excluding
the gas and electric supplies.
a) check that the combustion product exhaust
and any air intake ducts, including the external
terminals, are not obstructed or that their
material has deteriorated
b) clean the external parts of the air heater simply
by using a damp cloth
c) use a brush or a jet of compressed air to
remove the dust deposits on the external
surfaces of the exchanger, on the fan intake
grille and on the safety thermostat sensor
d) make sure that the operating phases are regular,
as described in point 11.3.

12.2 ANNUAL AIR HEATER INSPECTION

To reduce possible failures to a minimum and to
keep the air heater operating at peak efficiency,
and therefore providing the best output and
ensuring the lowest operating costs, it is
recommended to perform a general inspection of
the air heater at least once a year. More frequent
servicing may be required depending on the
environmental conditions where the air heater is
installed. Regular inspections area necessary,
especially in dirty areas, to assess the servicing
frequency.
page 40

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mec35-85c

Table of Contents