Crest Audio X-Eight HS Owner's Manual page 125

features
Crest Audio X-Eight consoles are equipped with a
which permits the user to set-up a series of
CONTROLLER
controlling any combination of channels and outputs. These scenes can
then be recalled, either singly or in combination, to allow the operator to
easily control the mutes during a performance.
The
MUTE CONTROLLER
eight
MANUAL MUTE SCENES
a single button,or remotely activated by the use of
mands.The can be combined with the
PATCHES
ferent combinations of channel mutes.
The following is an overview of the controls and indicators of the
and the channels. The following information pertains to X-
CONTROLLER
Eight consoles with Rev 1.12 firmware.
mute controller
A— /
UP DOWN
Each press of these switches increments or decrements the
B. Holding either button down will allow quickly scrolling up or down.The
buttons are also used to select the parameters and settings of the system
while in mode.
UTILITY
B—
DISPLAY
This four-character alpha-numeric display normally shows the current
being recalled.It is also used to display the parameters and set-
1–128
PATCH
tings of the system while in
C—
EDIT PREVIEW
Pressing this switch puts the system into
operator to view and change the contents of any selected
internal red LED will blink while in this mode, along with the status LED' s
J of any channels assigned to the selected
switch K will add or remove a channel from that scene. Pressing the
MUTE
/ switch again will exit back to normal operating mode.
EDIT PREVIEW
D—
EDIT SAFE
Pressing this switch puts the system into
ator to view and change the contents of the
green LED will blink while in this mode, along with any channels assigned
to the . Pressing a
SAFE SCENE
channel from the
SAFE SCENE
be muted from a
MUTE SCENE
nel all scenes without having to edit any of the scenes themselves. Pressing
the switch again will exit back to normal operating mode.
EDIT SAFE
microprocessor muting system
features 128
SEQUENCED SCENES
.The 128 can be stepped through using
PATCHES
MANUAL SCENES
mode.
UTILITY
/
EDIT PREVIEW
MUTE SCENE
EDIT SAFE
SAFE
switch K will add or remove a
CHANNEL MUTE
.If a channel is included in the
.This allows the operator to remove a chan-
MICROPROCESSOR MUTE
, each
MUTE SCENES
(patches) along with
patch-change com-
MIDI
to allow dif-
MUTE
PATCH DISPLAY
mode, allowing the
.The
MUTE SCENE
. Pressing a
CHANNEL
mode,allowing the oper-
memory. The internal
,it can't
SAFE SCENE
7
p. 125