Information Menu - Triumph Tiger Sport Owner's Handbook Manual

General Information
To access the units display:
Make sure the motorcycle is stationary.
Turn the ignition switch to the ON
position.
Press and release the SET button on the
left handlebar switch housing until
'SEtUP' is shown in the display screen.
Press and release the SCROLL button
until 'UnitS' is shown then press the SET
button. The units that are currently
active will flash.
Press and release the SCROLL button
until the required units are shown. Press
the SET button to confirm the units.
Units Display
Models with TPMS only:
Press the SET button and do not touch
the SCROLL or SET buttons again until
'PSI' or 'bAr' is shown.
Press and release the SCROLL button
until the desired tyre pressure units are
shown.
All Models:
Press the SET button and wait until
'UnitS' is shown, then press the HOME
button and the journey distance in the
trip 1 menu is shown in the display
screen.
42

Information Menu

To access the information menu:
Make sure the motorcycle is stationary.
Turn the ignition switch to the ON
position.
Press and release the SET button on the
left handlebar switch housing until 'InFo'
is shown in the display screen.
Note:
• InFo is shown in the display screen
for 0.5 seconds to indicate that the
information menu has been selected.
The display screen then changes to
display one of the items listed below.
Press and release the SCROLL button on
the left handlebar switch housing. The
display scrolls through the information
menu in the following order when
pressing down on the SCROLL button (it
will scroll through in the reverse order
when pressing up on the SCROLL
button):
• Cruise control set speed
• Range to empty
• Odometer
• Front tyre pressure
(if TPMS is fitted and activated)
• Rear tyre pressure
(if TPMS is fitted and activated)
• Instantaneous fuel consumption.
Each display provides the following
information.