Fluke 712 Instruction Manual page 6

Measuring an RTD
To measure an RTD, proceed as follows:
Press O to turn on the power.
1.
2. If the calibrator is in simulate mode (OUTPUT on the
display), press INPUT OUTPUT once. Make sure the display
shows INPUT.
R
3. Press
[
4. Press
wire RTD input configuration. Look for the 2W, 3W, or 4W
annunciator on the display to verify that the configuration is
set correctly.
5. Connect test leads to the RTD as shown below. Use two,
three, or four inputs, depending on the setting of 2W, 3W, or
4W on the display.
to select the desired RTD type.
{
or to select a two-wire, three-wire, or four-
4W
30V
MAX
NC
4W
INPUT
30V 30V
MAX MAX
2W 3W 4W
OUTPUT
RTD
3W
NC
3W
kg02f.eps