Fluke 712 Instruction Manual page 14

RTD Specifications
Since ohms input and output units are available, you
can use the calibrator for any unsupported RTD type by
selecting the ohms range and making manual
calculations or referring to tables.
Range °C (°F)
RTD Type
Ni 120
(-112.0 to 500.0)
Pt 100 385 -200.0 to 800.0
(-328.0 to 1472.0)
Pt 200 385 -200.0 to 250.0
(-328.0 to 482.0)
250.0 to 630.0
(482.0 to 1166.0)
Pt 500 385 -200.0 to 500.0
(-328.0 to 932.0)
500.0 to 630.0
(932.0 to 1166.0)
Pt 1000 385 -200.0 to 100.0
(-328.0 to 212.0)
100.0 to 630.0
(212.0 to 1166.0)
Pt 100 392 -200.0 to 630.0
(3926) (-328.0 to 1166.0)
Pt 100 JIS -200.0 to 630.0
(3916) (-328.0 to 1166.0)
Addresses pulsed transmitters and PLCs with pulses as short as 5 ms.
Allowable Excitation is for Output mode only. It shows the allowable excitation
current from an ohmmeter or RTD measurement device connected to the
calibrator.
Excitation current from 712: 0.2 mA.
Maximum input voltage: 30 V
-80.0 to 260.0
Note
Accuracy (°C)
Input
4-Wire 2-Wire
&
3-Wire
0.2 0.3
0.33 0.5
0.2 0.3
0.8 1.6
0.3 0.6
0.4 0.9
0.2 0.4
0.2 0.5
0.3 0.5
0.3 0.5
Allowable
Excitation
Output
(mA)
0.2 0.1 to 3.0
0.33 0.1 to 3.0
0.2 0.1 to 3.0
0.8
0.3 0.05 to 0.8
0.4
0.2 0.05 to 0.4
0.2
0.3 0.1 to 3.0
0.3 0.1 to 3.0